Meets D4 specs according to DIN EN 204.
High water and moisture resistance.
Easy to apply.
It can be sandpapered or trimmed after 2 hours.
Limited expansion.
Strong adherence for wood to wood and wood to other materials applications.
Paintable.
Solvent-free.

Adhering almost all types of wood surfaces with each other; metals, some types of plastics, stones, bricks, and concrete.
Adhering to wood construction materials and their repairs.
Manufacturing furniture and their repairs.
Yacht and boat construction industry.

Density: 1,10 g/ml 

Viscosity (20°C): 6.000-8.000 cps 

Open Time (20°C): 40 minutes

Clamping Time: 4 hours

Shelf Life: 12 months

Operating Temperature: -15°C to +100°C 

Application Surface Temperature: +10°C to +30°C 

Gross Weight: 750 gr

Applications performed below 5°C will not yield high enough performance in adhering.
Adhered surfaces should be clean and free from grease and dust.
Especially when adhering surfaces that do not contain or do not emit humidity, the surfaces are recommended to be dampened approximately 5% water compared to the amount of adhesive used.
The adhesive should be applied as a thin layer only to one of the surfaces which will be adhered to.
Surfaces should be put together and pressed before the open time of the product expires.

It contains diphenylmethane -4, 4 diisocyanates. If inhaled for long periods, it may cause sensitivity to respiratory organs. If the wet foam contacts the skin for long periods, it may cause local rash and sensitivity on the skin. For this reason, the environment should be well-ventilated during the application, contact with the skin should be avoided and protective gloves and safety goggles should be worn while working. Completely dried out PU adhesives do not carry risks to human health or to the environment.

It may take almost a day for the adhesive to fully dry out, during which time the parts should be carried around carefully.
The newly applied adhesive can be cleaned either by Promast Foam Cleanser.
It does not adhere to plastics such as PE, PP, nylon, and Teflon
For a strong adhesion, at least one of the surfaces should be porous.
The package is filled under nitrogen after the application makes sure there is no air left inside by turning it upside.