High efficiency up to 60 liters.
High consumption meets the low-cost requirements.
It has a small and regular cell structure.
Strong adhesion to most building materials.
Applies sufficient pressure to the surfaces with controlled growth.

Wall mounting of door and window frames.
Bonding of common building materials.
General-purpose filling and mounting applications.

Density: 21-23 kg/m³

Tack-Free Time: 8-10 minutes

Cutting Time: 25-35 minutes

Shelf Life: 15 months

Volume: 750 ml / 1000gr

Shrinkage: 5% max

Take out the straw off the lid and attach it to the valve by twisting.
Shake the can vigorously.
Moistening application surfaces would accelerate the drying speed and would have a positive effect on cell structure, efficiency, and adhesion strength.
While the can is upside down, press the trigger for the foam to come out.
Since the foam would expand, partially fill the gaps where you would apply.
From time to time, shake the can again during the application.
Leave the straw on the can for the next application; otherwise clean the valve with a solvent like acetone

It contains diphenylmethane -4, 4 diisocyanates. If inhaled for long periods, it may cause sensitivity to respiratory organs. If the wet foam contacts the skin for long periods, it may cause local rash and sensitivity on the skin. For this reason, the environment should be well-ventilated during the application, contact with the skin should be avoided and protective gloves and safety goggles should be worn while working. The aerosol can is filled with combustible propellant gasses under high pressure. For that reason they should not be punctures, should be kept away from heat sources or flames.

Maxi Foam will expand noticeably less compared with standard straw foams.
Moistening the surfaces prior to the application will improve adhesion and the cellular structure of the cured foams.
Cured foam must be protected from direct sunlight.